Honywell Wireless Smoke Detector
Honeywell’s 5806W3 is a 3V battery operated, photoelectronic smoke detector with a built-in wireless transmitter.
It facilitates fire verification for false alarm reduction requirements by ANSI/SIA CP-01standards and is intended for use
with any of Honeywell’s 5800 Series wireless receiver/transceivers for residential installations. The 5881ENHC or 5883H
receivers are required for commercial installations.
The transmitter can send alarm, tamper, maintenance (when control
panels are equipped to process maintenance signals) and battery condition messages to the system’s receiver. The maintenance
signal fully complies with the sensitivity test requirement specified in NFPA 72, 7-2.2 and is UL approved.
incorporates a state-of-the-art optical sensing chamber and advanced microprocessor. It also helps eliminate nuisance alarms
and virtually eliminates non-billable service calls and fines resulting from false alarms. The microprocessor allows the detector
to automatically maintain proper operation at factory calibrated detection levels, even when sensitivity is altered due to
the presence of contaminants settling into the unit’s smoke chamber. A removable detector cover and chamber top allows
the technician to quickly and easily clean the detector chamber without disassembling the detector head.
are no holes to drill or wires to run, installers can preserve the beauty of the protected premise while protecting it. The
5806W3 is an ideal smoke detector for difficult to wire locations, applications where room aesthetics are critical or where
hazardous materials exist.
- Smoothing Algorithms
calculations in the detector’s software that minimize nuisance alarms by smoothing out short term spikes from dust and
- Smart Check
A signal is sent to the control panel when the detector requires cleaning.
This allows a regular, non-emergency service call to clean the detector before it goes into alarm.
Virtually eliminates nuisance alarms from long-term dust build-up by automatically adjusting the
- Removable Detector Cover and Chamber Top
Provides the technician
the ability to quickly and easily clean the detector chamber without disassembling the detector head.
UL Listings for Residential and Commercial Applications
Both residential and commercial installation requirements
- Additional LED Status Indicators
Identifying between alarm or trouble conditions
is easier with green and red LED status indicators. The green LED denotes a normal condition while the red LED indicates an
- Easy-to-install Mounting Base
The sturdy mounting base allows the detector
to be more easily installed on uneven surfaces (i.e. stucco). The mounting base has larger mounting ports to accommodate drywall
anchors for easy surface mounting.
- Improved Robust RF Field Strength
The distance between
the detector and receiver has been significantly increased.